Home BeastX BXM76000 Micro Beast
BeastX BXM76000 Micro Beast
New Firmware V3
MICROBEAST has an aluminum composite design casing. Its slight dimensions
allow it to be installed in practically any model helicopter.
MICROBEAST can be installed horizontally as well as vertically.
The sensory system is based on the newest MEMS technology. Software
with sophisticated sensor data processing makes installation in electrical
& nitro model helicopters possible.
With an optional adapter cable, MICROBEAST can also be utilized solely
as a tail gyro. This is recommended especially for whoever is switching
from the conventional paddle system and wants to slowly approach the
RIGID operation with the 3 axle solution (3G-Gyro Mode).
The well-thought-out and easy setup goes smoothly with no need of an
expensive programming box or computer. This makes it easy to still change
a number of settings even at the airfi eld.
Moreover MICROBEAST′s integrated swashplate mixer enables the use
of simple remote control systems which do not have their own swashplate
MICROBEAST is able to process many types of sum signals (PPM / S-BUS
/ Spektrum / Multiplex SRXL). With the optional Spektrum Satellite Adapter, installation in
indoor model helicopters is also possible without a great number of
Updates and advanced setup possibilities (Setups) can be done comfortably
with the optional USB interface "USB2SYS" via the BEASTLINK
interface. Software for Windows & Mac can be downloaded free at
Operating voltage: 3,5V...8,5 V DC (Lipo 2s possible)
Processor: 32Bit ARM
Analog processing: 17Bit
Sensor technology: 3 MEMS angular rate sensors
Adjustable servo center pulse width:
Tail: 760µs / 960µs / 1520µs
Adjustable servo pulse rate:
Tail: 50 Hz / 165 Hz / 270 Hz / 330 Hz
Swashplate: 50 Hz / 65 Hz / 120 Hz / 200 Hz
Build-in swashplate mixer:
Mechanical / 90° / 120° / 140°
Size: 34 x 25 x 13,5 mm
Weight without cable: approx. 20 g
• Receiver connection cables
• Mounting material
• Adjust tool
• Instruction manual (for a moment only German/Franz)